HOWTO: Ethernet bonding in Debian Lenny

In an older post I explained how to create a bond interface in Debian Etch… now, this doesn’t work anymore due to some changes in Lenny.

So, long story short, first of all, install ifenslave

# apt-get install ifenslave-2.6

edit /etc/network/interfaces and add the bond0 config:

auto bond0
iface bond0 inet static
# dns-* options are implemented by the resolvconf package, if installed
up /sbin/ifenslave bond0 eth0 eth1
down /sbin/ifenslave -d bond0 eth0 eth1

now edit /etc/modprobe.d/arch/x86_64 (change the filename depending on your architecture) and add these lines

alias bond0 bonding
options bonding mode=1 miimon=100 downdelay=200 updelay=200

Brief explanation:

  • miimon N: check if the active interface(s) is alive every N milliseconds
  • downdelay N: wait N milliseconds after a detected link failure to consider the link down
  • updelay N: wait N milliseconds after a detected link restoration to consider the link up
  • mode N: 1 means master/slave configuration, so there’s only one active master. If this link fails, then slave is used.

For a more complete description of all the possible parameters, refer to Linux Documentation/networking/bonding.txt

After this, you can restart networking or reboot if you are working remotely and it should work without a problem. It did for me :)